It incorporates the flange to prevent different leakage. There are some versions that utilize what is commonly known as a donut gasket to aid in sealing the systems.
When it comes to donut gasket, it is a round in shape that uses a flat & smooth centre hole to ride solidly on the pipe. The outside diameter of the donut gasket is made from with a single slight angle on each side. When the flange is tightened, it is drawn into the flange & creates a solid seal, which contains sound, heat & fumes.
How To Repair, Exhaust Flange?
It is in a vulnerable location. You may also find out that it gets damaged easily. When you don't repair a broken one, you may find out that you'll get other issues along with the break. As it includes limiting the flow dynamic of gasses, and also even damages. Instead to be stuck with broken one, you must have time to fix it. You can easily repair it by yourself. It can be completed in a day and it will not be very difficult in order to manage by anyone with a very basic knowledge of car maintenance.
Things You'll Need: Brazing Rods, Acetylene Torch, Steel File, Brush & Vise
- To properly repair that, you'll need to first clean it thoroughly. It is required to remove rust, burned parts & extra things that would present at the end of the flange.
- Make sure that it must be oil & fuel free on the part where you will be going to fix it.
- Act upon the broken part in order to reassure yourself that it must fit back into the place. After it, hold the broken parts together.
- If you have a large piece of broken one, then you should consider replacing the pipe completely. A minor crack or small break can be fixed with the use of broken parts.
- When you have the broken parts, use an acetylene torch to heat them. Also, use an acetylene heat source for it. Bear in mind, this kind of flange holds up a lot of toxic flames. Therefore, be careful while handling it.
- Once the part of the metal is turned red in color & start bend, then use brazing tools to move the metal around the surface.
- Once the melting process is done from one side, then move them together with the help of the rods.
- When the melting process is done successfully & melted the broken parts into one. Now, you should hold the flange in place until the metal in increasing circles.
- Stay away the torch from it, eventually. When the metal is cooled down, remove the protruding lumps with a steel file. Now, remove the vise.
- Exhaust Cut Outs
- Ball Flange
- Exhaust Bland Clamps
- X & Y Pipes
- Smooth Transition Pipes
- Hot Rod Kits